ferrotec genius - Page 64

'$$,$
4)9& 
  !K-#L
9 =%)9$ 9# 8
9 7 %R95
S  9
).%%
###
9
Example 1: A evaporator with 4 pockets
In total 8 pockets should be selectable. Pocket 1 to 4 (real pockets) pocket 1A to 4A (virtual pocket). In
manual mode shall the pocket selection be made by the hand remote. In automatic mode shall the pocket
selection be made by 8 inputs. If pocket 1 is selected relay 1 on the CPU-card should be activated.
Settings:
In Menu Edit Process: Data and pockets are connected
In Menu Service I/O: Pocket Setting = 0
#  
9 _ 3$
9 _ 6?%
9 _ 6?%
9 _ 6?%
9 _ 6?%
9D _ 6D?%
9 _ 6?%
9 _ 6D?
90 _ 6?
9 _ J"
9 _ J"
9 _ J"
9 _ J"
?!BL _ 9
Example 2: A evaporator with 12 pockets.
48 pockets should be possible to select. Pocket 1 to 12 (real pockets) pockets 1A to 12C (virtual pockets). The
pocketselection is done by 6 Inputs, binary coded.
Input 1 = pocket 1 ...
Settings:
IIn Menu Edit Process: Data and pockets are connected
In Menu Service I/O: Pocket Setting = 2
#  
9 _6B J"
9 _ 6?%
9 _ 6?%
9 _ 6?%
9 _ 6?%
9D _ 6D?%
9 _ 6?%
+##
!0 =,()>