Festool CTL 26 E - Settings and Working Procedures; Adjusting Suction Power and Temperature Cut-out; AUTOClean Filter Cleaning; Extracting Dry Materials

14
CTL
Special features of CTL26 E SD
– CTL 26 E SD E/A: Socket module with automatic
switch-on function for the use of two electric
power tools: e.g. 2 sanders, 1 jigsaw + 1 sander
– CTL 26 E SD: Socket module with permanent
power supply for use as extension cable: e.g.
charger, lamp, etc.
6.4 Connecting pneumatic tools
WARNING
Risk of injury
XSwitch off the air tool.
Automatic on/off switch for air tools
(CTL 36/48 ELE, CTL 36/48 E LE AC
or accessories)
with compressed air module in module slot [1-2]
Recommendation:
– Attachment of service unit VE (495886): com-
pressed air filtered and lubricated
– Use of IAS system with IAS connector (454757)
for Festool air tools
– Requirement: tool with operating pressure of
6bar!
6.5 Special features of the CTL 36 E AC- LHS
To use the mobile dust extractor in combination
with the PLANEX:
XUse kink-resistant suction hose
D36mmx3.5m-AS.
XUse a special suction sleeve for connecting the
PLANEX.
XUse closing slide CT-VS between the intake
opening [1-1] and suction hose.
XAttach the tool holder.
XAlways use with a disposal bag!
7 Settings
7.1 Adjusting the suction power
XUse the rotary knob [1-9].
7.2 Temperature cut-out
A temperature cut-out switches the mobile
dust extractor off when it reaches a critical
temperature to prevent overheating.
XSwitch off the mobile dust extractor, allow to
cool for about 5 minutes then switch on again.
Not possible to switch on: contact Festool
service workshop.
7.3 AUTOClean - Cleaning the main filter (only
versions with AutoClean)
Only in conjunction with disposal bag
(compliance with dust class ’L’). Not suit-
able for wet extraction!
Automatic cleaning
Adjust the frequency using the rotary knob [1-7].
Only CTL for 36 E AC-LHS: switch on using the
rotary knob [1-7].
Manual cleaning
Turn the switch [1-8] to the AC symbol.
Full manual cleaning
XCover the end of the nozzle or suction hose with
your hand or closing slide CT-VS (497926) for
2 seconds.
XTurn the switch [1-8] to the AC symbol.
8 Working
8.1 Extracting dry materials
CAUTION
Hazardous dust
Damage to the respiratory passage
XAlways use a filter or disposal bag!
When extracting dust that exceeds the
permitted limit values, only extract from
a single machine (electric or air tool).
Observe the following when extracting dust
generated by operating electric power tools:
Ensure there is adequate ventilation! Observe
regional regulations!
Limit values: exhaust air max. 50% of the clear
air volume
Formula: room volume V
R
x air renewal rate L
W
8.2 Extracting wet materials/liquids
Remove the filter or disposal bag!
Recommendation: use special wet filter (NF-CT).
The dust extractor stops automatically when the
maximum level is reached.
After wet extraction, allow the main filter to dry!
CAUTION
Escaping foam and fluids
XSwitch off and empty the machine immediately.