► Attach the cord holder to the reverse of the
mobile dust extractor (see figure [3]).
► Connect the suction hose to the machine.
6.2 Switching on/off
► Insert the mains plug into an earthed sock
et.
WARNING
Risk of injury from tools starting up unex
pectedly
► Before setting the switch to the "AUTO" or
"MAN" position, make sure that the con
nected tool is switched off.
The switch [1-11] serves as an on/off switch.
"0" switch position
Appliance socket [1-4] is disconnected from the
power, mobile dust extractor is switched off.
"MAN" switch position
Appliance socket [1-4] is connected to the pow
er, the mobile dust extractor starts.
"Auto" switch position
Appliance socket [1-4] is connected to the pow
er, the mobile dust extractor starts when the
connected power tool (see 7.2 ) or com
pressed-air tool (see 7.3 ) is switched on.
7 Settings
7.1 Adjusting the hose diameter
► Adjust the hose diameter adjuster [1-9] to
match the inner diameter of the connected
suction hose.
This ensures that the air speed in the ex
tractor hose is measured correctly (see
section 7.10 ).
7.2 Connecting electric power tools
WARNING
Risk of injury
► Observe the maximum appliance socket
connected load (see chapter "Technical da
ta")
► Switch off the electric power tool.
► Connect the electric power tool to the appli
ance socket
[1-4].
7.3 Connecting a compressed-air tool
WARNING
Risk of injury
► Switch off the compressed-air tool.
Automatic switch-on for compressed-air tools
on mobile dust extractors
with compressed-air module in the module
slot [1-3].
7.4 Adjusting the suction power
► at the rotary knob [1-10].
7.5 Connecting sleeve
The bypass function of the connecting sleeve
prevents strong suction from sanding machines
and floor nozzles on smooth surfaces.
Open
► Turn the adjusting ring to the "OPEN" posi
tion.
Close
► Turn the adjusting ring to the "CLOSE" posi
tion.
7.6 Applying the brake
Folding out the black brake lever [1-15] pre
vents the mobile dust extractor from rolling. To
achieve this, lift the front end of the mobile dust
extractor slightly and push the black brake lev
er downwards until it latches into place. Push
the green lever [1-14] to release.
7.7 Temperature cut-out
To prevent overheating, a temperature cut-out
switches the mobile dust extractor off when it
reaches a critical temperature.
► Switch off the mobile dust extractor and al
low to cool for about 5 minutes.
If the mobile dust extractor will not switch
on again, please contact a Festool service
workshop.
7.8 Changing the filter bag (SC FIS-CT
26/36/48)
Removing the filter bag [4]
► Open the locking clips [2-2] and remove the
top section of the machine
[2-1].
► Remove the filter bag.
► Dispose of the used filter bag in accordance
with statutory regulations.
► Clean the dust container [2-3].
Inserting the filter bag [5]
► Insert a new filter bag (SC FIS-CT 26/36/48)
in the inlet port of the dust container and in
English
19
To Next Page