Festool CTM 26 E - Working

terlock it. Important: be aware that the
locking engages.
► Replace the top section [2-1] and close the
locking clips [2-2].
Make sure that the filter bag is not pinched
between the top and bottom sections.
7.9 Changing the disposable bag (variants
with AutoClean only)
Removing the disposal bag [6]
► Close off the extractor opening [1-2] using
the sealing plug [1-1].
► Open the locking clips [2-2] and remove the
top section of the machine [2-1].
► Close the disposal bag.
► Remove the disposal bag.
► Dispose of the used disposal bag in accord
ance with statutory regulations.
► Clean the dust container [2-3].
Inserting the disposal bag [7]
► Insert a new disposal bag (ENS-CT26/36/48)
on the inlet nozzle of the container and lock
in position.
Important: The lateral openings on the dis
posal bag must be positioned inside the
container. Make sure that the bolt engages.
► Place the disposal bag over the edge of the
container.
Make sure that the contacts [10-2] are
free.
► Replace the top section [2-1] and close the
locking clips [2-2].
7.10 Volumetric flow monitoring
For safety reasons, an acoustic warning signal
sounds if the air speed in the suction hose falls
below 20 m/s (dust class M only).
The table on the mobile dust extractor ex
plains this connection for the minimum re
quired extraction volume of the respective
hose diameter. If this extraction volume is
not reached, a warning signal sounds.*
* only with EU versions of CT AC
Possible causes Solution
Value set on the suc
tion power adjust
ment [1-10] is too
low.
Set the suction power
adjustment to a high
er value (see sec
tion 7.4).
Rotary knob [1-9] not
set to the correct
hose diameter.
Set the correct suc
tion hose diameter
(see section 7.1).
Suction hose is
blocked or kinked.
Eliminate the block or
straighten the hose.
Filter bag full. Insert a new filter bag
(see section 7.7).
Dirty main filter. Change the main filter
(see section 9.1).
AUTOClean ONLY:
Clean the main filter
(see chapter 8.2).
Electronic monitoring
malfunction.
Have the fault recti
fied by a Festool serv
ice workshop.
Wet extraction. Function not impaired,
no measures re
quired.
ONLY CTM 36 E AC-
LHS with PLANEX
LHS 2 225:
In tasks that require
a low extraction set
ting (e.g. on soft sur
faces).
Activate bypass func
tion on special extrac
tion sleeve [1A].
8 Working
8.1 Handling
Hose holder: After finishing work, you can feed
the suction hose through the opening [8-2] and
place it in the hose holder.
SysDoc Systainer storage area: A Systainer can
be fastened to the storage area with the four
slides or the T-Loc lock [8-1].
8.2 AutoClean – cleaning the main filter
(variants with AutoClean only)
Only in conjunction with a disposable
bag (to comply with dust class "M"). Not
for use during wet extraction.
English
20