EasyManua.ls Logo

Festool CTM MIDI I - Service and Maintenance; Exhaust Management and Filter Maintenance; Filter Replacement and Post-Work Procedures

Festool CTM MIDI I
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CAUTION
Hazardous dust
Damage to the respiratory passage
After extracting wet materials, remove the
wet filter and replace it with the main filter
for dry materials.
CAUTION
Escaping foam and fluids
Switch off and empty the machine immedi
ately.
8.3 Exhaust-air outlet
CAUTION
Hazardous dust
Damage to the respiratory passage
Do not blow off any dust!
The exhaust-air outlet offers the option of di
verting the exhaust air outside a building using
the suction hose.
Open the grille in front of the exhaust open
ing
[1-14].
Insert the suction hose in the exhaust open
ing [1-14].
8.4 Cleaning the filter and filter bag
manually
In standby mode, press the MAN but
ton [1-17].
Set the suction power to the maximum set
ting
[1-18].
Cover the suction hose with your hand while
at the same time briefly pressing down the
cleaning lever [1-16] three times.
8.5 Changing the filter bag with minimal
dust
Open the locking clips and remove the top
section of the machine [2].
Pull the tab on the filter bag until the filter
bag opening is fully closed.
The filter bag is now securely closed and can be
removed.
Fit the top section of the machine and close
the locking clips.
8.6 Changing the filter element
Pull out the used filter drawer [1-15].
Dispose of the used filter drawer in accord
ance with statutory regulations.
Insert the new filter drawer [1-15].
Order numbers for accessories, fil
ters and consumables in the Festool
catalogue or online at "www.fes
tool.com".
NOTICE
Damage to the motor
Never extract material without a main filter
or with a damaged main filter, as this can
damage the motor.
8.7 After finishing work
Switch off the mobile dust extractor and
pull out the mains plug.
Wind up the mains power cable.
Empty the dirt trap.
Place the suction hose [4-1] in the sealable
hose holder [1-7]. Place the mains power
cable
[4-2] in the sealable hose hold
er [1-7] or wind it up on the cord holder. To
do so, lay the power cable through the re
cess [4-3].
Vacuum and wipe the inside and outside of
the mobile dust extractor to clean it.
Place the mobile dust extractor in a dry
room inaccessible to unauthorised users.
The lid of the hose holder also serves
as a storage area for tools.
9 Service and maintenance
WARNING
Risk of injury, electric shock
Always pull the mains plug from the socket
before performing any servicing and main
tenance work.
All maintenance and repair work which re
quires the motor housing to be opened
should always be carried out by an author
ised service workshop.
Customer service and repairs must only be
carried out by the manufacturer or service
workshops: Find the nearest address at:
www.festool.com/service
English
19

Table of Contents