14
ETS 125 REQ
GB
9 Service and maintenance
Customer service and repair
only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
Only use original Festool spare parts!
Order No. at: www.festool.com/service
The machine is equipped with special carbon
brushes. If they are worn out, the power is inter-
rupted automatically and the machine comes to a
standstill.
To ensure constant air circulation, always keep the
cooling air openings in the motor housing clean and
free of any obstruction.
In the event of a slowdown in performance or in-
creased vibrations, blow and clean cooling air
openings.
10 Accessories
Use only original Festool sanding pads. Low-quality
sanding and polishing pads may cause serious ma-
chine imbalances that decrease the quality of the
work results and increase wear on the power tool.
The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under "www.festool.com".
11 Environment
Do not dispose of electric power tools in house-
hold waste!
Recycle devices, accessories and
packaging. Observe applicable country-specific
regulations.
EU only:
In accordance with European Directive on
waste electrical and electronic equipment and im-
plementation in national law, used electric power
tools must be collected separately and handed in
for environmentally friendly recycling.
Information on REACh:
www.festool.com/reach
Sanding work Adjusting
wheel set-
ting
– Sanding with max. abrasion
– Sanding off old paint
– Sanding of wood and veneered surface
prior to paintwork
– Intermediate sanding of paintwork on sur-
faces
5 - 6
– Sanding thinly applied undercoat
– Sanding wood with sanding cloth
– Edge breaking on wooden parts
– Smoothing primed wooden surfaces
4 - 5
– Sanding solid wood and veneered edges
– Sanding rebate of windows and doors
– Intermediate sanding of paintwork at edg-
es
– Light sanding of natural wood windows
using sanding cloth
– Smoothing wooden surfaces using sand-
ing cloth before staining
– Rubbing or removing excess limestone
residue using sanding cloth
3 - 4
– Intermediate sanding of paintwork on
stained surfaces
– Cleaning natural wood window rebate us-
ing sanding cloth
2 - 3
– Sanding stained edges
– Sanding of thermoplastics
1 - 2
WARNING
Risk of injury, electric shock
Always disconnect the mains plug from the
socket before performing maintenance work on
the machine!
All maintenance and repair work which requires
the motor housing to be opened must only be
carried out by an authorised service workshop.
EKAT
1
2
3
5
4
To Next Page
Loading...
