To Next PageTo Next Page
Need help?Do you have a question about the Festool LEX 2 125/3 and is the answer not in the manual?
General| Power Consumption | 400 W |
|---|---|
| Orbit Diameter | 3 mm |
| Pad Diameter | 125 mm |
| Vibration Level/Emission | 2.5 m/s² |
| Sanding Stroke | 2.5 mm |
| Dust Extraction Connection Diameter | 27 mm |
| Dust Extraction | Yes |
Processing compressed air using a Festool service unit for optimal tool function, including filter, control unit, and lubricator.
Details on the IAS 2 hose connector system, combining compressed air supply, exhaust air extraction, and dust extraction.
Instructions for commissioning the pneumatic tool by operating the lever for on/off functions.
Regulate tool speed steplessly between 4,000 and 8,000 rpm using the adjusting wheel for optimized cutting speed.
Dust extraction through channels in the sanding pad; recommends Festool extractors and avoiding operation on standstill tools.
Information on different sanding pad weights, fitting correct sizes, and available hardness degrees for various applications.
Affixing self-adhesive abrasives to sanding pads and ensuring concentric alignment with holes for proper function.
Recommendation for replacing motor vanes after approximately 500 operating hours for continued performance.
Details on the sanding pad brake collar, its function to prevent uncontrolled vibration, and replacement procedure.
Instructions for lubricating the machine with 1-2 drops of oil into the compressed-air supply for longer periods of non-use.
Importance of regular replacement of the silencer on the IAS 2 connecting piece to maintain pneumatic tool power.
Recommendation to clean extraction channels weekly using a pipe-cleaner brush or cloth, especially after sanding resin filler.
