4 Technical data
Eccentric sanders ETS 125REQ
Performance 250 W
Speed (idle)
6000 - 12000 rpm
Max. speed
[2]
16000 rpm
Sanding stroke 2,0 mm
Sanding pad D 125 mm
Weight (without mains ca
ble, with sanding pad)
1,2 kg
5 Parts of the machine
[1-1]
On/off switch
[1-2]
Plug-it connection
[1-3]
Speed control
[1-4]
Extractor connector
[1-5]
Sanding pad
[1-6]
Protector
[1-7]
Long-life dust bag
[1-8]
Dust bag adapter
[1-9]
Handle (insulated gripping surfaces)
The specified illustrations appear at the begin
ning of the Operating Instructions.
6 Operation
WARNING
Unauthorised voltage or frequency.
Risk of accidents
► The mains voltage and the frequency of the
power source must correspond to the
specifications on the machine's name
plate.
► In North America, only Festool machines
with the voltage specifications 120 V/60 Hz
must be used.
CAUTION
Heating of the Plug it connection if bayonet
fitting is not completely locked
Risk of burns
► Before switching on the power tool, make
sure that the bayonet fitting at the mains
cable is closed fully and locked.
Connecting and detaching the mains power ca
ble - see figure .
The switch [1-1] serves as an on/off switch (I =
ON, 0 = OFF).
If there is a power failure or the mains
plug is removed, move the on/off switch
immediately to the Off position. This pre
vents uncontrolled restarting.
7 Settings
WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
7.1 Electronics
Smooth start-up
The electronically controlled smooth start-up
ensures that the machine starts up jolt-free.
Constant speed
The preselected motor speed is kept constant
through electronic control. This means that, if
the machine is used as intended (reasonable
contact pressure), a constant sanding speed is
achieved.
Setting the speed
The speed can be adjusted between 6000 and
12,000 rpm using the adjusting wheel [1-3].
This enables you to optimise the sanding speed
to suit the material you are working on (see
Section
8 ).
7.2 Replacing the sanding pad [3]
An optimal work result can only be ach
ieved using original accessories and con
sumables. The use of non-original accessories
or consumables invalidates the right to claim
under warranty.
[2] Max. speed in the event of faulty electronics.
English
15
To Next Page
Loading...
