5
Symbols
Warning of general danger
Read the Operating Instructions/Notes!
Wear protective goggles
Wear a dust mask
V volts
A amperes
Hz hertz
W watt
~ alternating current
n
0
no load speed
Class II Construction
rpm revolutions per minute
spm strokes per minute
Intended use
The sanders are designed for sanding wood, plastic,
composite materials, paint / varnish, fi lling mate-
rial and similar materials. Metal and materials
with an asbestos content must not be processed
with these tools.
The machine is particularly suitable for processing
smaller surfaces and overhead work because of its
size, its weight and its output.
The machines must not be damp nor operated in a
damp environment for electrical safety reasons. The
machines may only be used for dry sanding.
The user bears sole responsibility
for any damage or accidents resulting from incor-
rect use.
Electrical connec-
tion and operation
The mains voltage must correspond with the voltage
on the rating plate!
See the following Fig. for connecting or disconnect-
ing the power cord of the tool.
Always switch the machine off before
connecting or disconnecting the power cable!
Technical data
Wattage 200 W
No load speed 5000 - 14000 rpm
No. of strokes 10000 - 28000 spm
Sanding stroke 2.0 mm (0.079 in.)
Sanding base (delta form)
80 x 130 mm (3.1 x 5.1 in.)
Weight 1.1 kg (2.4 lbs.)
Safety level
/ II
To Next Page
Loading...
Need help?
General