Festool RTSC 400 Li Original Instructions

Use four screws to tighten it by hand
(2.5 Nm).
4A
DTSC 400 Li
RTS
C 400 Li
9.3 Attaching sanding accessories using
StickFix [4B]
The suitable StickFix sandpaper and StickFix
sanding cloth can be attached quickly and sim
ply to the StickFix sanding pad.
► Affix the self-adhesive sanding accessory to
the sanding pad.
4B
DTSC 400 Li RTSC 400 Li
9.4 Dust extraction
WARNING
Dust hazard
► Dust can be hazardous to health. Always
work with a dust extractor.
► Always read applicable national regula
tions before extracting hazardous dust.
Integral dust extractor with long-life dust bag
As standard, the sanders are equipped with an
integral dust extractor. The sanding dust is ex
tracted through extraction openings in the
sanding pad and is collected in the dust bag.
Installing the dust bag [5]
Slide the dust bag onto the machine until it
clicks into place.
1
5A
If the suction power is decreasing, empty
the dust bag.
Press the dust bag onto the actuating ele
ments.
Remove the dust bag by moving it towards
the rear.
Open the flap on the dust bag.
Empty the dust bag and dispose of the waste.
2
1
2
3
4
5B
Dust extraction with Festool's mobile dust ex
tractor
To prevent having to frequently empty the dust
bag when carrying out sanding work for a long
period of time, you can connect Festool's mo
bile dust extractor (with an extraction hose di
ameter of 27 mm) to the extractor connection
piece [1-4].
The start-up mode switches the mobile
dust extractor on as soon as you switch
the orbital sander on. The start-up mode
only works in conjunction with the mains
adapter.
English
9

Festool RTSC 400 Li Specifications

General

Brand	Festool
Model	RTSC 400 Li
Category	Sander
Language	English