Both hard and soft pads are available.
Festool materials are offered in Brilliant,
Rubin or Saphir (shown right) up to 400
grit.
I often hand cut much finer grits from
other size materials and use them on the
DX 93 when I want very fine finishes in
very tight corners. With no holes in my
hand cut abrasives the dust collection is
not good so I have to be careful to fre-
quently wipe away the residual sanding
dust. Dust collection with the Festool
supplied materials which do have the
proper holes is excellent.
The photo on the right shows the relative
sizes of the DX 93 (right) and the DX 400
(left). The tape measures may help you
visualize the absolute size of each.
To Next Page
Loading...
