10
MXC
GB
5Technical data
6Operation
6.1 Charging the battery pack [1]
Charge only battery packs that are designat-
ed for use with the charger. (see Intended
use)!
The LED
[1-3]
on the charger indicates the respec-
tive operating status of the charger.
6.2 Charger wall mount
The charger MXC has two elongated holes on its
back. It can be mounted on a wall using two screws
(e.g. round head or flat head screw with shank di-
ameter of 5 mm) (see Fig.
[1]
).
7 Service and maintenance
Observe the following instructions:
– Keep the air slits on the machine and the charger
free and clean to ensure adequate cooling.
– Keep the contacts on the machine, charger and
battery pack clean.
Customer service and repair
only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
Only use original Festool spare parts!
Order No. at: www.festool.com/service
8 Accessories
The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under "www.festool.com".
9 Environment
Do not dispose of the device in house-
hold waste!
Recycle devices, accesso-
ries and packaging. Observe applica-
ble national regulations.
EU only:
In accordance with European
Directive on waste electrical and electronic equip-
ment and implementation in national law, used
electric power tools must be collected separately
and handed in for environmentally friendly recy-
cling.
Information on REACh:
www.festool.com/reach
10 EU Declaration of Conformity
Charger MXC
Mains voltage (input) 220 - 240 V ~
Mains frequency 50/60 Hz
Charging voltage (output) 10.8 V=
Rapid charging typ. 2.8 A
Charging times for
LiIon 1,5 Ah approx. 23/ min
LiIon 2,6 Ah approx. 45 min
Permitted operating tempera-
ture range
-10 °C to + 40 °C
Temperature monitoring via NTC-resistor
Safety class /II
WARNING
Unauthorised voltage or frequency!
Risk of accident
The mains voltage and the frequency of the pow-
er source must correspond with the specifica-
tions on the machine's name plate.
In North America, only Festool machines with
the voltage specifications 120 V/60 Hz may be
used.
LED yellow - lit continuously
Charger is ready to use.
LED green - flashing quickly
Charging battery pack at maxi-
mum rate.
LED green - flashing slowly
Charging battery pack to 80% and
with reduced current.
LED green - lit continuously
Charging process is charged.
LED red - flashing
General fault indicator, e.g.
incomplete contact, short circuit,
defective battery pack, etc.
LED red - lit continuously
Battery temperature is outside
permissible limit values (0 °C to
55 °C).
Charger Serial no.
MXC 495883
Year of CE mark: 2010
EKAT
1
2
3
5
4
To Next Page
Loading...
