Programing Instructions for ExtractorExtractor
TM
Coffee Brewing Systems
FETCO, LUXUS, Extractor, Millenia, Pulse-Brew are all trademarks or registered trademarks of FETCO.
Turn the brewer off by pressing the main power switch
(located under the front panel, directly behind the front
leg). Press the main power switch again to turn the unit on.
Display will read “Stby”.
Quickly hold the stop button for 3 seconds. The display will
read “Prg” while you are holding in the stop button. After 3
seconds the display will read the software version and then
switch to the programing display.
The programming display shows 2 series of numbers. The
first series shows the batch number and parameter number.
For example 1.1 = batch 1, parameter 1. The second series
of numbers is the setting for that specific parameter.
Advance to Next
Parameter
Scroll Up
Scroll Down Save Changes
and Exit
Need help?
General
