fetra 6833 - Assembly; Intended use

www.team−hosta.de
20
Transport equipment
Assembly
Before unpacking the device, make sure to read to operation manual.
Do not lift the lifting table cart from the box, but rst cut open one side and
then roll the car from the packaging.
Attach the push handle to the frame by tightening the screws, or for the
tiltable version, insert and lock in operational position.
Attach the bowden cable for actuating the lowering valve to the lever on
the hydraulic cylinder.
Insert the foot pedal for pumping up the table into the intended opening
on the platform and secure with the attached screws.
Intended use
The lifting table cart described in this manual is designed for lifting, lowering
and transporting goods in in-house operation.
The lifting table cart must be used, maintained and repaired in compliance with
the specications in this manual.
Any other usage of the device is not allowed and may lead to injury or damage.
The lifting table cart may not be used in environments with re or explosion
hazard, extremely high dust exposure or in corrosive environments.
The device should never be operated in lighting conditions below 50 Lux.
The operating temperature may be between -10°C and +40°C.
The lifting table cart may only be used in well ventilated rooms or outdoors, the
ground conditions should be solid, level, free of holes, obstacles and not prone
to skidding.
The lifting capacity specied on the type plate may not be exceeded, no unba-
lanced loads may be lifted.
The operator must make sure that the lifting table cart is only used as intended
and that any hazards for health and life of the user or other persons is avoided.
www.team−hosta.de