MR25664
12
OPERATION
Starting a Cut:
1. To begin a cut, adjust the depth cylinders to
the desired depth with the planer slightly
above the ground. Engage the hydraulic
system to start the drum. Lower the planer
bringing the front wheels onto the ground.
2. Continue lowering the planer until the rear
wheels are on the ground and the drum is
milling the material.
3. Slightly lift the front loader wheels to create
a downward force on the planer. Slowly
move forward, planing in a straight line.
NOTE: Materials can vary greatly: it is recommended that cutting depth be limited to 1 inch when
roughing concrete. Deeper cuts in concrete should be made in multiple passes.
WARNING! Failure to obey the following procedures could result in death or serious
injury.
• Never lift this product above (a) the operator’s eye level or (b) to a height
where visibility is obstructed, whichever is lower.
• Never operate your Planer with the cover open.
To Next Page
Loading...
