Need help?Do you have a question about the Fiat 127 and is the answer not in the manual?
General| Brand | Fiat |
|---|---|
| Model | 127 |
| Category | Automobile |
| Language | English |
Overview of the 1049 cc overhead camshaft engine design, support, and component removal sequence.
Step-by-step instructions and precautions for refitting the crankshaft and main bearings.
Procedure for refitting piston rings as per Chapter 1, Section 42.
Instructions for the reassembly of pistons and connecting rods, noting valve depression placement.
Guidance on refitting pistons into the engine, noting valve depression placement.
Details on reassembling connecting rods to the crankshaft, including torque specifications.
Instructions for reassembling the Hobourn-Eaton type oil pump, including component details.
Steps for cleaning, lubricating, and fitting crankshaft oil seals and carriers.
Procedure for refitting the engine sump, emphasizing gasket use and bolt tightening.
Instructions for cleaning, lubricating, and fitting the auxiliary shaft and its seal.
Steps for fitting the toothed pulley, tensioner bracket, plunger, and tensioning wheel.
Guidance on reassembling the cylinder head, valves, tappets, shims, and camshaft.
Instructions for refitting the distributor, including setting the contact breaker gap and timing.
Procedure for replacing the toothed drivebelt, including timing marks and tensioning.
Detailed steps for checking and adjusting valve clearances, including shim replacement.
Concluding steps for the 1049 cc engine final assembly, including manifold gasket fitting.
General information on carburettor types for the 1049 cc engine, including Weber and Solex.
Details on removal, refitting, dismantling, and adjustment for single venturi carburettors.
Procedures for removal, refitting, dismantling, and adjustment of the dual venturi carburettor.
General guidance and recommendations for overhauling carburettors, including obtaining repair kits.
To Next Page
