GEAR SELECTOR OVERRIDE
If a malfunction occurs and the gear selector cannot be moved out of the PARK position,
you can use the following procedure to temporarily move the gear selector:
1. Turn the engine OFF.
2. Firmly apply the parking brake.
3. Remove the gear selector override access cover (loca ted on the right side of the gear
selector housing) by prying at the bottom edge of the cover.
4. Press and maint ain firm pressure on the
brake pedal.
5. Insert a small screwdriver or similar tool
into the access hole, and push and hold
the override release lever in.
6. Move the gear selector to the NEU-
TRAL position.
7. The vehicle may then be started in
NEUTRAL.
8. Reinstall the gear selector override ac-
cess cover.
Gear Selector Override Access Hole
WHAT TO DO IN EMERGENCIES
127
To Next Page
