Fiat Linea - Page 153

152
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
IINDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE
CAR
IN AN
EMERGENCY
Versions with steel rims
Proceed as follows:
❒ make sure the contact surfaces be-
tween spare wheel and hub are clean
so that the fastening bolts will not come
loose;
❒ fit the standard wheel by inserting the
first bolt for two threads into the hole
closest to the inflation valve;
❒ fit the wheel cap making the lunette
hole coincide with the bolt you have fit-
ted then, fit the other 3 bolts;
❒ using the wrench provided, tighten the
fastening bolts;
❒ lower the car and remove the jack;
❒ using the wrench provided, fully tight-
en the bolts in the sequence shown
previously in the figure.
Versions with alloy rims
Proceed as follows:
❒ insert the wheel on the hub and using
the wrench provided tighten the bolts;
❒ lower the car and remove the jack;
❒ using the wrench provided, fully tight-
en the bolts in the sequence shown in
the figure.
When you have finished
❒ stow the spare wheel in the space pro-
vided in the boot;
❒ fit the jack partially open in its box
C-fig. 2 forcing it lightly to prevent it
from vibrating when travelling;
❒ put the tools back into their places in
the container;
❒ stow the container C-fig. 2, complete
with tools in the spare wheel;
❒ tight the tool box fastener A-fig. 2;
❒ reposition the mat in the boot.
145-176 LINEA 1ed GB 5-09-2008 9:22 Pagina 152