6
FIAT PANDA 4 x 4
❒
make sure the space-saver spare wheel
supporting surfaces on the hub are
clean and free from any impurities that
could cause wheel bolts loosening;
❒
fit the space-saver spare wheel match-
ing one of the wheel holes O with pins
N-fig. 8;
❒
fasten the four fastening bolts;
fig. 8
F0G0204m
fig. 9
F0G0206m
fig. 10
F0G0615m
❒
turn the jack handle to lower the car
and remove the jack;
❒
fasten the bolts completely, working in
a criss-cross fashion as shown in fig. 9.
After changing the wheel
❒
put the jack partly open and the tools
used into the tool bag;
❒
stow the bag with tools into its place
under the driver’s seat.
IMPORTANT Replaced wheel shall be
placed in the boot under the cover mat as
shown in fig. 10.
IMPORTANT Do not use inner tubes
with tubeless tyres. Check tyre and space-
saver spare wheel pressure regularly.
IMPORTANT Changing original wheels
with others of different type (i.e.: with al-
loy rim instead of steel rims and vice ver-
sa) will involve to change the whole set
of wheel bolts with others of suitable
length. It is however recommended to
keep replaced bolts in the event of future
refitting of the original wheels.
To Next Page
Loading...
