Fiat Panda 4x4 - IF AN EXTERIOR LIGHT BURNS OUT; FRONT LIGHT UNITS

7
FIAT PANDA 4 x 4
IF AN EXTERIOR LIGHT
BURNS OUT
(Fiat Panda 4 x 4 CROSS
version)
IMPORTANT To change an external light
on Fiat Panda 4 x 4 and Fiat Panda 4 x 4
Climbing versions, refer to the Owner
Handbook this Supplement is attached to.
For the type of bulb and power rating re-
fer to paragraph “When needing to change
a bulb” in section “In an emergency” in the
attached Owner Handbook.
FRONT LIGHT UNITS
To change the dipped beam bulb, proceed
as follows:
❒ remove the cover A-fig. 11;
❒ disconnect the connector C-fig. 12;
❒ release the bulb holder catch A;
❒ remove the bulb B and fit the new bulb.
To change the front sidelight bulb, pro-
ceed as follows:
❒ remove the cover A-fig. 11;
❒ remove the bulb holder A-fig. 12
❒ remove the bulb B;
❒ fit the new bulb.
To change the front fog light bulb, proceed
as follows:
❒ remove the cover A-fig. 11;
❒ disconnect the connector D-fig. 14;
❒ turn slightly the bulb holder B and re-
move it;
❒ remove the bulb C and fit the new bulb.
To change the main beam bulb, proceed
as follows:
fig. 11
F0G0617m
fig. 12
F0G0618m
fig. 13
F0G0619m
fig. 14
F0G0628m
604.39.016 PANDA 4X4 GB 6-05-2008 13:22 Pagina 7