JACK
Important notes:
❒ the jack weight is 1.76 kg;
❒ the jack requires no adjustment;
❒ the jack cannot be repaired and in the event of a
fault it must be replaced by another original one;
❒ no tool other than its cranking device may be
fitted on the jack.
To change a wheel proceed as follows:
❒ stop the car in a position that is not dangerous for
oncoming traffic where you can change the wheel
safely. The ground must be flat and sufficiently
compact;
❒ switch off the engine, pull up the handbrake and
engage the 1
st
gear or the reverse gear. Wear the
reflective safety jacket (compulsory by law in
certain countries) before getting out of the car;
❒ open the luggage compartment, pull tab A fig. 108
and lift up the mat;
❒ using the wrench A fig. 109 located in the tool
box, loosen the locking device, take the tool box B
and place it close to the wheel to be replaced.
Then take the space-saver wheel C;
❒ take the wrench A fig. 110 and loosen the fixing
bolts by about one turn;
❒ position the jack under the car, near the wheel to
be changed;
fig. 108
F0W0325
fig. 109
F0W0183
150
GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
To Next Page
Loading...
