Fiat PANDA - TONE ADJUSTMENT (Bass;Treble); Balance Adjustment; Fader Adjustment; Loudness Function

❒ LOUDNESS (LOUDNESS function
activation/deactivation);
❒ EQUALISER (activation and selection of factory-
set equaliser levels);
❒ USER EQUALISER (customised equaliser setting).
TONE ADJUSTMENT (bass/treble)
Proceed as follows:
❒ Use
or buttons to set the “Bass” or “Treble”
in the AUDIO menu;
❒ press the
or button to increase/decrease the
bass or treble.
By pressing the buttons briefly, the levels will change
progressively. By holding them down longer, the levels
will change quickly.
BALANCE ADJUSTMENT
Proceed as follows:
❒ Select the "Balance" setting in the AUDIO menu
using the
or button;
❒ press the
button to increase the volume of the
right speakers or the
button to increase the
volume of the left speakers.
By pressing the buttons briefly, the levels will change
progressively. By holding them down longer, the levels
will change quickly.
Select the value "
0 " to set the same level for
the right and left audio outputs.
FADER ADJUSTMENT
Proceed as follows:
❒ Select the "Fader" setting in the AUDIO menu
using the
or button;
❒ press the
button to increase the sound from the
rear speakers or the
button to increase the
sound from the front speakers.
By pressing the buttons briefly, the levels will change
progressively. By holding them down longer, the levels
will change quickly.
Select the value "
0 " to set the same level for
the front and rear audio outputs.
LOUDNESS FUNCTION
The Loudness function improves the volume of the
sound whilst listening at low volumes, increasing the
bass and treble.
To activate/deactivate the function, select the
Loudness setting of the AUDIO menu using the
or
buttons.
The condition of the function (on or off) is shown on
the display for a few seconds by the wording
“Loudness On” or “Loudness Off”.
250
SOUND-SYSTEM