BODYWORK
PROTECTION AGAINST ATMOSPHERIC
AGENTS
The car is equipped with the best available
technological solutions to protect the bodywork
against corrosion.
These are the most important:
❒ painting products and systems which give the car
particular resistance to corrosion and abrasion;
❒ use of galvanised (or pretreated) steel sheets, with
high resistance to corrosion;
❒ spraying of plastic parts, with a protective function
in the more exposed points: underdoor, inner
wing, edges, etc;
❒ use of “open” boxed sections to prevent
condensation and pockets of moisture from
triggering rust inside.
BODY AND UNDERBODY WARRANTY
Your car is covered by warranty against perforation
due to corrosion of any original element of the
structure or body.
For the general terms of this warranty, refer to your
Warranty Booklet.
PRESERVING THE BODYWORK
Paintwork
Touch up abrasions and scratches immediately to
prevent the formation of rust.
Maintenance of paintwork consists of washing the
car: the frequency depends on the conditions and
environment where the car is used. For example, in
highly polluted areas, or if the roads are spread
with salt, it is advisable to wash the car more
frequently.
To correctly wash the car, proceed as follows:
❒ remove the aerial from the roof to prevent damage
to it if the car is washed in an automatic system;
❒ if high pressure jets or cleaners are used to wash
the car, keep a distance of at least 40 cm from
the bodywork to avoid damage or alteration.
It should be remembered that the build up
of water can damage the car over a period of time;
❒ wash the body using a low pressure jet of water;
❒ wipe a sponge with a slightly soapy solution over
the bodywork, frequently rinsing the sponge;
❒ rinse well with water and dry with a jet of air or a
chamois leather.
202
GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
To Next Page
Loading...
