175
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
❒
install the space-saver spare wheel
matching the holes S-fig. 8 with the
corresponding pins T;
❒
using the wrench provided, fully tight-
en the four fastening bolts;
❒
work the jack handle R-fig.7 to lower
the car and remove the jack;
❒
using the wrench provided, tighten up
the wheel bolts in a criss-cross fashion
following the sequence shown in fig. 9.
REFITTING THE STANDARD
WHEEL
Following the procedure described previ-
ously, raise the car and remove the spare
wheel.
Versions with steel rims
Proceed as follows:
❒
Make sure the contact surfaces be-
tween standard wheel and hub are
clean so that the fastening bolts will not
come loose;
❒
Fit the normal wheel matching the
holes S-fig. 8 with the corresponding
pins T;
❒
Using the wrench provided, tighten the
fastening bolts;
❒
Lower the car and remove the jack;
❒
Using the wrench provided, fully tight-
en the bolts in the sequence shown in
fig. 9;
❒
Place the cap near the wheel so that the
inflation valve can come through the
slot provided on the cap;
❒
Press the circumference of the cap,
starting from the parts nearest the in-
flation valve until it is inserted com-
pletely.
IMPORTANT Incorrect fitting may cause
the wheel cap to come off when the car is
travelling.
fig. 8
F0C0396m
fig. 9
F0C0397m
To Next Page
Loading...
