Fiat Stilo 2006 - Page 186

185
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
DIPPED BEAM HEADLIGHTS
fig. 22
Gas-filled filament lamps
To change the bulb, proceed as follows:
❒ remove the protective cover releasing
the catch;
❒ release the bulb holder catch A;
❒ disconnect the electric connector B;
remove the bulb C and replace it;
Gas-discharge lamps (Xenon)
(where provided)
MAIN BEAM HEADLIGHTS fig. 23
To change the bulb, proceed as follows:
❒ remove the protective cover releasing
the catch;
❒ release the bulb holder catch A;
❒ disconnect the electric connector B;
remove the bulb C and replace it;
❒ fit the new bulb, making the tabs of the
metallic part coincide with the grooves
on the reflector, reconnect the electri-
cal connector B then hook the bulb
holder catch A;
❒ refit the protective cover correctly.
fig. 22
F0C0178m
fig. 23
F0C0179m
Due to high voltage, the bulb
of (Xenon) gas-discharge
headlights must only be replaced by
experts: danger of death! Contact Fi-
at Dealership.
WARNING
❒ fit the new bulb, making the tabs of the
metallic part coincide with the grooves
on the reflector, reconnect the electri-
cal connector B then hook the bulb
holder catch A;
❒ refit the protective cover correctly.