0
Using Keypad
Start and cancel
heating cycle
Power ON/OFF
Set
Heate
Reset
Splice program Heater program SD Power Time
Heater panel
Control panel
Home Screen icons
Display the Settings panel
Power source type
Change image view
Display/Non-display icons
Start the splicing process
Start the heating process
View splice data after splicing
Adjust the zoom of a fiber image
Adjust display brightness
Capture a fiber image
To display the Settings panel, tap the
Settings panel icon ( ) on Home screen.
■Settings panel
■Home screen
Display the menu screen.
Set up Splice Program.
Set up Heater Program.
Log in to Administrator
mode by entering passcode.
Adjust the volume.
Perform an arc test.
Settings panel icons
CA6
Quick Reference Guide
To Next Page
Need help?
General