Safety Precautions
For your correct and safe operations on the equipment, please carefully read and strictly observe
the following safety instructions:
◆ High optical power can cause bodily harm, especially to eyes. Never look directly into the
end of the optical transmitter fiber jumper or the end of its active connector.
◆ Exercise care if you must bend fibers. If bends are necessary, the fiber bending radius
should never be less than 38 mm.
◆ Overloaded power sockets or damaged cables and connectors may cause electric shock or
fire. Regularly check electrical cables. If any of them is damaged, replace it immediately.
◆ Use the power supply adapter provided in the package only. Using other adapters may
cause equipment damage or operation failures.
◆ Install the equipment in a well-ventilated environment without high temperature or direct
sunlight to protect the equipment and its components from overheating, which may result in
damage.
◆ Cut off the power supply for the equipment in lightning weather and disconnect all the wires
and cables (such as the power cable, network cable and phone cable) from the equipment,
so as to prevent the equipment from being damaged by lightning.
◆ Do not place the equipment in a wet or damp environment. Water seepage will lead to
abnormal operation of the equipment and short circuit, which may cause dangers and
should be prohibited. ◆ Do not lay this equipment on an unsteady base.
I
Contents
Safety Precautions..................................................................................................I
1 Documentation Guide .....................................................................................1
To Next Page
Loading...
Need help?
General
Weight and Dimensions
