1. Control Function Description
➢ “ON/OFF”key：Turn ON/OFF the heat pump.
➢ “MODE”key：Press MODE key to select :
AUTO mode – Triangle Sign
COOLING mode – Snowflake sign
HEATING mode – Sunshine Sign
➢ CLOCK key：Time setting ( NOT AVAILABLE ON MOST MODELS)
Press this key, then SET. Use the up and down arrows to set the current time. Use M button to
swap between hour/ minute settings There is NO TIMER. This is only to set the time. You DON'T
have to set the time, it does not effect the operation of the heater at all.
➢ UP AND DOWN “”and“”key：
Press “”and“”key to set the target temperature in the main interface.
➢ “SET” key：
Press this key to enter the fault query state, and then press this key to query other fault displays in
the current state.
Press and hold SET key to enter parameter state, then press “MODE” key to enter the setting.
You can set the parameters by pressing “”“” key, press “SET” key to set other
parameters.exit the parameter setting state automatically if there is no operation within 5 seconds.
FOR A HOMEOWNER, ALL YOU NEED TO SET IS THE HEATING AND COOLING
TEMPERATURES. YOU DON’T NEED TO GO INTO ADJUSTING PROGRAMS. SIMPLY, PRESS
MODE TO GO TO HEATING, USE THE ARROWS UP AND DOWN . THATS ALL
THE FACTORY SETTINGS ON THE SYSTEM ARE DELICATE. AND THERE IS NO FACTORY
RESET OPTION. THEREFORE, WE DO NOT RECOMMEND A HOMEOWNER TO ATTEMPT TO
CHANGE OPERATIONAL SETTINGS.
V-2105 Fibropool Co LLC, Ms USA
To Next Page
Loading...
