SYSTEM PARAMETERS
***************************************WE DO NOT RECOMMEND CHANGING FACTORY SETTINGS.
THERE IS NO FACTORY SETTINGS- RESET BUTTON. THE ONLY OPTION IS TO
REPROGRAM THESE FUNCTIONS INDIVIDUALLY OR REPLACE THE MOTHERBOARD. IN
MOST CASES, THE ERROR/ PROBLEM WILL GO AWAY BY RESTARTING THE SYSTEM.
JUST TURN OFF THE BREAKER FOR 45 SEONDS AND TURN IT BACK ON. THIS WILL
ERASE THE SENSORS' MEMORIES.*************************************************************
V-2105 Fibropool Co LLC, Ms USA
No Parameter Name Range Default Remark
0 Memory Function during power off 1 Adjustable
1 Timer Cycle- Daily 0 (no) /1 (yes) 1 Adjustable
2
Adjustable
3
Adjustable
4 Defrost duration 30-90 Min 40Min Adjustable
5
Defrosting trigger coil temperature
Adjustable
6 Defrosting – off coil temp.
7 Max Defrost Duration 1-12Min 8Min Adjustable
8 Compressor exhaust gas protection 90-120 (194-248 )℃ ℉ Adjustable
9 Max desired temperature Unvalid
10 1 N/A
11 3-20MIN 15 N/A
12 Second anti- freezing mode 1 fixed
13 Heat- Cool Mode Selection 1 Adjustable
14 High pressure switch 1
15 Low pressure switch 2
16 Water flow switch 1
17 Emergency switch 2
18 Electric heater over heat protection -
19 Inlet water temp. -9~99℃
20 Outlet water temp. -9~99℃
21 Coil temp -9~99℃
0 (no) /1 (yes)
X(Temp- Difference between compressor
Start – desired setting( accuracy)
2-10°C (35.6-50°F)
3 ℃ (37.4 )℉
Y(Temp Difference between compressor
Stop and Desired temperature ( Accuracy)
0-3°C (32-37.4°F)
0 ℃ (32 )℉
-30°C~0°C ( "-" and "°C" not
display)
-1 (only display ℃
“1”)
110 (230 )℃ ℉
25~40 (℃ 77-104 )℉ 40 (104℃ ℉)
Water pump running mode – DISABLED
2021 0（Special）\1（Normal）
Pump Firemans Switch timer – DISABLED
2021
0（HP）/1（Electric heater）
0(cooling only)\1（cooling and
heating）\2（heating only）
0: Alarm when closed
1: Alarm when open
2: Invalid
0: Alarm when closed
1: Alarm when open
2: Invalid
0: Open when abnormal
1: Close when abnormal
2: Invalid
1: Enable
2: Disable
1: Alarm when open
2: Invalid
Measured
Measured
Measured
To Next Page
Loading...
