Fidelis Network Series - Fidelis Network Integration with K2; Registering Collector Controller 10 G with K2; Linking Fidelis Sensors to Collector Controller

QUICK START GUIDE
Fidelis Network™ High Capacity Collector
www.fidelissecurity.com ©Fidelis Cybersecurity
9
5. Review the list of IP addresses. Select Confirm if these are correct, or select Edit to correct
them.
9. Fidelis Network Integration
Register Collector Controller 10G with K2
1. Log into the K2 GUI from a web browser.
2. Add the Collector to the K2 at the System>Components page. Click Add Component.
3. Select Collector from the drop down menu. Complete the form:
- name — this is a user-friendly name for the Collector, not the FQDN of the Controller.
- IP address of the ADMIN interface of the primary Collector Controller 10G appliance
- (optional) description — e.g. location, business unit, etc.
- Click Save.
4. Register the Collector to K2. Click Register and accept the End User License Agreement
(EULA). K2 will then communicate with the Collector at the specified IP address.
Register Collector Controller 10Gs with the Fidelis Sensors
1. Log into the K2 GUI from a web browser.
2. Select the appropriate Direct, Internal, Mail or Web sensor and click Config.
3. Click the Advanced page for the sensor and select a Collector at the drop down box.
4. Repeat for each sensor.