EN
CORDLESS RECIPROCATING SAW USER’S MANUAL
19
Specific safety instructions | Hearing protection | Operation
on it; and make sure that the cord will not be subjected to any damage.
A risk of injury exists in the case that instructions in this manual are not followed. The jigsaw complies with
valid technical regulations and norms.
When working with the jigsaw, the protective cover must always be pushed down.
Regularly check both screws on the clamp of the saw blade.
Do not use damaged or worn saw blades.
Regularly check the setting of the guide pulley.
Do not turn the saw on if the saw blade slid into the workpiece.
Never overload the saw so much that the engine ceases.
Never try to stop the movement of the saw blade, even when the engine is turned off.
The saw blade itself is removed very quickly. The blade’s teeth are very sharp.
Never aim the saw at another person.
Use protective gear against noise, dust and vibrations!!!
WARNING! Keep these safety instructions!!!
6. HEARING PROTECTION
WARNING! In case the sound pressure level exceeds the value of 90.2 dB(A), wear adequate hearing
protection to avoid damage to your hearing!
7. OPERATION
Working with a jig saw
(for quick start see picture 2 - 8)
WARNING! The saw is exclusively dedicated to home or hobby use. The manufacturer and importer do not
recommend using this tool in extreme conditions and excessive loads. Any kind of further requests must be the
subject of agreement between the manufacturer and customer.
The tool is an electronic speed controlled, pendulum action jig saw. The adjustable speed and 3-stage
pendulum action gives an enhanced cutting performance and optimum curve-cutting action, saving the
blade from wear. Before using the jig saw, read the instructions thoroughly and acquaint yourselves with its
features.
Make sure that the working area is clear of all obstacles particularly on the reverse side of the cut. If you use
the saw with one hand always ensure your free hand is away from the cutting area.
Saw blade replacement
( see picture 14a-14f)
WARNING! Turn off the jig saw and unplug the power supply cable from the socket.
Select a saw blade as applicable for the material to be cut.
Lift the plastic transparent cover, turn the keyless chuck to the right, insert the blade all the way (teeth facing
you) and release the keyless chuck.
Insert the blade into the blade holder, ensuring that the teeth are pointing forward and the flat back edge of
the blade locates in the guide roller.
Close the protective plastic transparent cover.
To Next Page
Loading...
