Fieldmann 50004550 - Machine Care; Warranty

EN
CORDLESS RECIPROCATING SAW USER’S MANUAL
21
Cutting according to the template
(see picture 13a-13i)
In special cases, when you will need cut out exact form, please work according to the pictorial instructions.
ON/OFF switch
(see picture 8 + 10)
The on/off switch (3) is located in the saw handle.
Depress the trigger switch to turn on the jig saw.
The on/off switch can be locked with the locking button on the side of the saw handle.
To unlock the switch, depress the switch button again. Always ensure that the switch is in the off position
before connecting the tool to the mains. Always disconnect the tool from the mains when not in use.
Cleaning and Storing Instructions
WARNING! Prior to maintenance and cleaning, ensure the power is disconnected from the saw. Unplug the
power cable from the power supply network. Use only mild soap and a slightly damp cloth to clean your saw.
Many household cleaners contain chemicals which could seriously damage the plastic. Do not use petrol,
turpentine, lacquer or paint thinners or similar products to clean the machine. Never let any liquid get inside
the tool and never immerse any part of your saw into liquid.
Never use water or other liquids to clean the electrical parts of the tool.
Always clean the tool after use.
Ensure the ventilation slots do not become blocked to prevent overheating.
Check the carbon brushes regularly (dirty or worn carbon brushes result in excessive sparking and speed
faults). We recommend only in official service point.
Always replace the carbon brushes in pairs.
8. MACHINE CARE
Overload
Never use excessive force when cutting. Too much pressure reduces the speed of the machine, and the required
power is greatly reduced. This may result in overload which can damage the motor of the machine. When the
machine becomes too hot, allow it to run for two minutes at no load and then interrupt working for a short time.
Clean the machine with a clean cloth and a brush. Ensure that the ventilation slots are not blocked.
9. WARRANTY
The Warranty Card shall be valid only when submitted together with the purchase receipt. Keep the both
documents in a safe place. To lodge a warranty complaint, turn to your dealer or a service centre. The warranty
shall apply to all product defects and faults that occurred during the warranty period and were demonstrably
attributable to material or manufacturing defects. In such cases the product shall be repaired and/or adjusted.
The warranty shall not apply to standard wear of the product, as well as to faults attributable to overloading,
using of inappropriate accessories or improper operation of the product.
Machine care | Warranty