Do not put hands in the vicinity of the rotating tool. The kick-back of the tool may throw the
operators arm away.
Do not stand in the area, into which the tool might be thrown by the kick-back. Kick-back will
throw the tool in the opposite direction to the movement of the disk at the moment of
seizure.
Pay special attention to the machining of corners, sharp edges etc. Prevent skipping and
seizure of the tool. Corners, sharp edges or skipping tends to cause seizure of a rotating
tool and loss of control or kick-back.
Follow the manufacturer's instructions while selecting the sand paper. Large sand
paper, which extends over the grinding disk, represents a risk of tearing and may
cause seizure, tearing of the disk or a kick-back.
5. USE AND OPERATION
This angle grinder is intended for household or hobby use only.
The manufacturer and importer do not recommend using this tool in extreme
conditions and under high load.
Any other additional requirements must be agreed between the manufacturer
and the customer.
Use the machine and attachments (note the manufacturer‘s specifications) only
for the intended range of applications.
Any other use is strictly forbidden.
Additional safety instructions for surfacing
Safety warnings specific for surfacing:
OPERATING INSTRUCTIONS
BELT SANDER
Carefully unpack and inspect your sander. Fully familiarise yourself
with all functions/features of the tool
Ensure that all parts of your sander are present and in good
condition. If any part is missing, or damaged, have such parts
replaced before attempting to use this tool. Always use dust
extraction where available, or a dust bag where not
EN 12 Specific safety instructions | Use and operation
To Next Page
Loading...
