Troubleshooting
Suspected malfunctions are often due to causes the user can fix themselves. Therefore
check the product using this section .In most cases the problem can be
solved quickly .
WARNING!
Only perform the steps described within these instructions! All further inspection ,
maintenance and repair work must be performed by an authorized service
centre or a similarly qualified specialist if you cannot solve the problem yourself !
Problem
Possible Cause
Solution
1.Product does not start
1.1 Not connected to power
supply
1.2 Power cord or plug is defective
1.3 Other electrical defect to the
product
1.1 Connect to power supply
1.2 Check by a specialist
electrician
1.3 Check by a specialist
electrician
2.Product does not reach
full power
2.1 Extension cord is not suitable
for operation with this product .
2.2 Power source（e.g.
generator）
has too low voltage
2.3 Air vents are blocked
2.1 Use a proper extension
cord
2.2 Connect to another
power source
3.Unsatisfactory
result
3.1 Drill is dull/damaged
3.2 Drill bit is not suitable for work
piece material
3.1 Replace with new
one 3.2 Use proper Drill
4.Excessive vibration
or noise
4.1 Drill bit is dull/
damaged
4.1 Replace with a new
one
EN 14 Technical specifications
FDTP 2100-E
To Next Page
Loading...
