Fieldmann FDUV 70105-0 - Product Description and Specifications; Operation

EN 8
FDUV 70105-0
Product description and specifications | Operation
3. PRODUCT DESCRIPTION AND
SPECIFICATIONS
1. Trigger
2. LED
3. Keyless chuck
4. Torque selector collar
5. Application selector collar (01A-18Li only)
6. Speed selector
7. Control switch
8. Handle
9. Battery (not included)
4. OPERATION
WARNING!
Always remove battery pack before changing or removing accessories. Only use
accessories specifi callyrecomended for this tool. Others may be hazardous. To reduce
the risk of injury, always wear safety goggles or glasses with side shields.
Installing Bits
Always remove the battery before inserting or removing bits. Select the proper style and size bit for the job. This
tool is equipped with a spindle lock. The chuck can be tightened with one hand, creating higher grip strengths on
the bit.
1. To open the chuck jaws, turn the sleeve in the counterclockwise direction. When using drill bits, allow the
bit to strike the bottom of the chuck. Center the bit in the chuck jaws and lift it about 1/16” off of the bottom.
When using screwdriver bits, insert the bit far enough for the chuck jaws to grip the hex of the bit.
2. To close the chuck jaws, turn the sleeve in the clockwise direction. The bit is secure when the chuck makes
a ratcheting sound and the sleeve can not be rotated any further.
3. To remove the bit, turn the sleeve in the counterclockwise direction.
Note:
A ratcheting sound may be heard when the chuck is opened or closed. This noise is part of the locking feature,
and does not indicate a problem with the chuck’s operation.
Selecting Hammer, Drill or Drive Action
1. To use the hammer-drilling mode, rotate the application selector collar until the hammer symbol
appears in line with the arrow. Apply pressure to the bit to engage the hammering mechanism. (Fig. 1)
Note:
The number selected on the torque selector collar has no effect on operation of the drill in hammer mode.