EN
CORDLESS DRILL USER’S MANUAL
Product description and specifi cations
11
For reverse (counterclockwise) rotation, push in the control switch from the left side of the tool. Check the
direction of rotation before use.
To lock the trigger, push the control switch to the center position. The trigger will not work while the control
switch is in the center locked position. Always lock the trigger or remove the battery pack before performing
maintenance, changing accessories, storing the tool and any time the tool is not in use.
WARNING!
To reduce the risk of injury, always hold or brace securely.
Starting, Stopping and Controlling Speed
1. To start the tool, grasp the handles fi rmly and pull the trigger.
Note:
An LED is turned on when the trigger is pulled.
2. To vary the speed, increase or decrease the pressure on the trigger. The further the trigger is pulled, the
greater the speed.
3. To stop the tool, release the trigger. Make sure the bit comes to a complete stop before laying the tool down.
Drilling
Place the bit on the work surface and apply fi rm pressure before starting. Too much pressure will slow the bit and
reduce drilling effi ciency. Too little pressure will cause the bit to slide over the work area and dull the point of the
bit. If the tool begins to stall, reduce pressure slightly to allow the bit to regain speed. If the bit binds, reverse the
motor to free the bit from the workpiece.
To Next Page
Loading...
