FZN 2505-E
14E N Technical data
13. TECHNICAL DATA
Voltage/Frequency 230
~
240 V/50 Hz
Idling speed
Input power
Blade length
Maximum cutting diameter
Weight
Instructions Manual - language version only.
14. WHAT TO DO "WHEN..."
The following table describes the inspections and procedures you may perform if your tool is not
working properly. If these instructions do not help in identifying or remedying the problem, please
contact an authorised service centre.
WARNING!: Turn off the tool and disconnect the power plug from the socket before
troubleshooting.
When... Possible cause Remedy
The hedge trimmer
is not working
– No power supply
– Faulty power socket
– Damaged extension cord
– Check the power supply
– Try a different power socket, replace it
– Check the power cord and if necessary
replace it (Contact an authorised service
centre)
The hedge trimmer
is not work
intermittently
– Damaged extension cord
– Internal electrical wiring fault
– Damaged power switch
– Check the power cord and if necessary
replace it
– Immediately contact an authorised service
centre
– Immediately contact an authorised service
centre
The motor is running
but the blades are not
moving
– Internal fault – Immediately contact an authorised service
centre
The trimmer's cutting
blades are hot
– Blades are blunt
– Trimmer's cutting blades are deformed
– Excessive friction caused by an insufficient amount
of lubricant
– Have the blades sharpened
– Have the blades repaired
– Use a lubricant in a spray
1700 ot./min
600 W
550 mm
20 mm
2,60 kg
Declared noise level 100db(A)
Maximum vibration level 2.755m/s2 K=1.5m/s2
To Next Page
Loading...
