Fieldmann FZV 6050 B - Page 12

EN 12
FZV 6050 B
Safety Instructions
Do not use the cultivator when it is raining or if the grass is wet.
Proceed especially carefully when working in elevated terrain (on a slope). Always work perpendicular to the
slope, parallel to the contour, and not directly up/down.
Under no condition leave the cultivator running without supervision; if you leave the cultivator, turn off the
engine.
Never lift the rear part of the cultivator when starting it and always keep your limbs away from the chassis or
rear ejection hole when the engine is running.
Never modify the engine's speed setting.
Never transport the cultivator while its engine is running.
Stop the engine and disconnect the spark plug in the following cases:
- when performing any task whatsoever around the cylander or in the rear grass ejection chute.
- when performing maintenance, repairs or inspecting the machine.
- before carrying, lifting or transporting it.
- if you leave the cultivator unattended or are about to adjust the cultivation depth setting.
- when an impact with a foreign object occurs, stop the engine and carefully inspect to ensure that there is
no damage. In the event of damage, take the cultivator.to a specialised service centre for repairs.
ATTENTION: When the engine is switched off, the blades continue to rotate for a few seconds.
- if the cultivator is vibrating abnormally (immediately identify and remedy the cause of the vibration).
- for the purpose of ensuring safe operation, regularly check that the pins, bolts and nuts on the cultivator
are securely tightened.
ATTENTION: FUEL IS A VERY FLAMMABLE LIQUID.
Store fuel in a suitable container.
Only add fuel in an open and well ventilated location. When handling fuel, do not smoke or use a mobile
phone.
Only add fuel when the engine is turned off. Never open the fuel tank or add fuel if the engine is hot or if it is
running.
If fuel is spilled, do not start the engine. Take the cultivator away from the location where the fuel was spilled
and take care to avoid possible ignition. Continue with work only after the spilled fuel has evaporated and the
fuel fumes have dissipated.
After adding fuel, securely tighten the fuel tank cap and the cap on the fuel canister.
ATTENTION: Before carrying out maintenance or repairs, stop the engine and disconnect the spark plug.