Fiery EFI ES-3000 - Maintenance and Cleaning; Cleaning the ES-3000; Safety Guidelines; General Safety Precautions

7
Release the button when all patches in the strip have been scanned, and you reach the white space at the end of
the strip.
If the light on the ES-3000 flashes green, the strip measurement is successful.
If the light on the ES-3000 is blue, the first pass of a two-pass measurement is successful, and the ES-3000 is
ready for the second pass of the same strip.
If the light on the ES-3000 flashes red and an error message is displayed, you must measure the same strip again.
Maintenance and cleaning
Clean the plastic housing of the ES-3000 with a damp cloth. Clean the white reference ceramic tile on the calibration
cradle with isopropyl alcohol on a soft, clean cloth.
e following procedure describes how to clean the measurement tube on the ES-3000.
1
Turn the ES-3000 upside down.
2
Turn the aperture cover clockwise and remove it.
3
Slide the slider with the protection glass out of the aperture.
4
Clean the glass and the inside of the aperture with isopropyl alcohol on a soft clean cloth.
5
Reassemble the aperture with the protection glass slider. Make sure that the slider snaps back into its original
position.
6
Insert the aperture cover and turn it counterclockwise to lock it in place.
Safety
Follow safety guidelines to protect the ES-3000.
Do not use the instrument in environments where explosion hazard exists.
Do not use the instrument in environments with temperatures higher than 40°C or lower than 10°C.
Do not store the instrument in environments with temperatures higher than 70°C or lower than -20°C.
Protect the instrument from chemical agents, corrosive vapors, strong vibration and mechanical impact.
Use only the power supply supplied by the manufacturer. Use only accessories and spare parts supplied by the
manufacturer.
Do not spill liquids on the ES-3000.
Do not drop the ES-3000 into liquids.
Do not try to dismantle the ES-3000 for any reason. Unauthorized dismantling of the device voids all warranty
claims.
Use the ES-3000 on a stable surface and do not expose it to sunlight and moisture.
Setup Guide
EFI ES-6000 Spectrophotometer
5