1.4 Function DESC
5
Handlebar
Battery
ChargingPort
(Insert the Fiido charger ONLY)
(The right side is rear brake)
(Open/close to adjust the handlebar)
Rear Brake
(Gently press down the button to
switch to the pure electric mode, the
stonger the press,the faster the speed)
Electric mode button
Quick Release
( To connect the Fiido Mate cycling watch,
please simultaneously press the "M" button
and "Power-assisted Shift Up" buttons. The
Bluetoothconnection icon will blink during
the connection process. Once connected, the
icon will remain solid.)
Connect with bluetooth
(When the controller temperature is too high,
this icon will be displayed and the output
power will be relatively reduced, to reduce
high load operation amd restore power).
Overheat Protection
(Display the current power assisted gear.)
Power Assisted Gear Display
(Shows the status of the front and rear light.)
(When the Battery power is less than 10%,
this icon will be displayed, and the power
output willbe weakened. Please charge in time.)
ECO Mode
(Display remaining power.)
Battery Status
(Display the current speed.)
Lights
Instrument Power
(① Click to switch the display of spec.
② Double-click the button to turn on/off the
front light.)
Speed
(In case of overtaking, road section affecting
safety visibility or emergency, slow down
and ring the bell for signal.)
Bell Button
Instrument Power
(Long press for more than 3 sec：turn on/off the
power assisted mode.)
(① Click to switch the gear and PAS 0, a
total of 3 gears
② Double-click to switch KMH/MPH display.
③ Long press for 3 seconds,
when the speed display enters the
flashing state, the cruise control function
can be started.)
Power Assisted Gear Switch
To Next Page
Loading...
