4
Operating Instructions:
❶
Plug unit into outlet. (Green indicator located on the power On/Off switch will illuminate,
indicating that the unit has power and not that the unit is turned On.)
❷
Press power On/Off switch to the On (“ I ”) position. When the unit is turned on initially,
all indicators located on the front panel will illuminate for two seconds. The green Power
On Indicator(leaf) will illuminate and remain lit as long as the unit’s power switch is in
the On (“ I ”) position.
❸
The unit will start running at low speed. (Low-Speed Indicator will illuminate.)
❹
The Up and Down Arrow Buttons located on the front panel can now be utilized for
speed control as follows:
Down Arrow Button: Press to decrease motor speed selection(motor speed will
not change if unit is already operating at low speed).
Up Arrow Button: Press to increase motor speed selection (motor speed will not
change if unit is already operating at high speed).
Caution:
• Liquid or spray scents, aroma therapy oils or other aromatic hydrocarbons with
the Defender
®
could cause damage to the plastic housing. Damage to the plastic
housing could expose moving parts.
•To reduce the risk of injury from moving parts. Do not use with liquid or spray
scents, aroma therapy oils or other aromatic hydrocarbons.
• Use of these substances will void your warranty.
Programming Instructions:
Program mode allows you to set and activate a 24-hour continuous operation program loop.
To Initiate Program Mode:
❶
Turn off unit.
❷
Press and hold the Down Arrow Button while turning on unit.
❸
Once the green Power On Indicator(leaf) is illuminated, release the Down Arrow Button.
The unit is now in program mode, indicated by the flashing High-Speed Indicator. Follow
the instructions below to set your desired program sequence.
To Set a Program Sequence:
The motor speed must be set in twelve consecutive two-hour increments totaling 24 hours of
operation.
Program Sequence Start Time: The sequence will begin its cycle with the first two-hour
increment immediately after the twelfth two-hour increment is programmed. Please be sure to
consider the program sequence start time when planning your desired program sequence.
❶
Plan your desired program sequence using the table on page 5.
❷
Select the desired motor speed for the first two hours of operation by pressing the Down
Arrow Button. (High speed is currently selected. Press the Down Arrow Button once to
select medium speed, twice to select low speed, and three times to select motor off.)
❸
Once you’ve selected the motor speed for the first two-hour time increment, press the Up
Arrow Button to lock in the speed. (After each two-hour speed selection has been locked in,
the red Filter Replacement Indicator will flash.)
❹
Continue to set each consecutive two-hour increment by selecting the speed with the Down
Arrow Button and then locking in each selection with the Up Arrow Button.
Operation
ENGLISH
To Next Page
Loading...