FilterQueen Defender - Operation and Maintenance; Operating Instructions; Usage Cautions

Operating Instructions:
1. Plug unit into outlet. (Green indicator located on the power On/Off switch will illuminate,
indicating that the unit has power and not that the unit is turned On.)
2. Press power On/Off switch to the On (“I”) position. When the unit is turned on initially,
all indicators located on the front panel will illuminate for two seconds. The green Power
On Indicator (leaf) will illuminate and remain lit as long as the unit’s power switch is
in the On (“I”) position.
3. The unit will start running at low speed. (Low-Speed Indicator will illuminate.)
4. The Up and Down Arrow Buttons located on the front panel can now be utilized for
speed control as follows:
Down Arrow Button: Press to decrease motor speed selection (motor speed will
not change if unit is already operating at low speed).
Up Arrow Button: Press to increase motor speed selection (motor speed will not
change if unit is already operating at high speed).
CAUTION:
• Liquid or spray scents, aroma therapy oils or other aromatic hydrocarbons with the
Defender
®
could cause damage to the plastic housing. Damage to the plastic housing
could expose moving parts.
• To reduce the risk of injury from moving parts, do not use with liquid or spray scents,
aroma therapy oils or other aromatic hydrocarbons.
• Use of these substances will void your warranty.
Remember, to receive the full benefit from your Defender
®
, replace your filters regularly.
• Every 6 months, replace your Enviropure
®
Charcoal Filter.
• Once a year (for Perpetual Warranty*), replace your Medi-Filter
®
Cartridge.
*Refer to the warranty for information on warranty extension (Perpetual Warranty).
CAUTION: Disconnect from power supply before servicing. Do not wash or try to clean
filters in any way. Regular replacement is recommended.
Filter Replacement Schedule
3
Operation