EasyManua.ls Logo

FilterQueen Defender - Filter Management; Filter Replacement Indicator; Resetting the Indicator Timer

FilterQueen Defender
9 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Filter Replacement Indicator:
Your Defender
®
is equipped with a Filter Replacement Indicator located on the front
panel. Anytime this red indicator flashes, it is recommended that you call your Authorized
FilterQueen
®
Distributor or call 1-440-846-7800 to order a replacement filter. Anytime
this red indicator stops flashing and remains solidly illuminated, it is recommended that
you change your filter. To receive the full benefit from your Defender
®
and to extend your
warranty, it is strongly recommended that you follow the filter replacement schedule. Under
higher pollution levels, your filters will need to be replaced more frequently.
The Filter Replacement Indicator is operated by filter time in use and is controlled by an
onboard timer. After 11 months of time in use of your Medi-Filter
®
Cartridge, the Filter
Replacement Indicator will begin to flash. It will continue to flash until the you reach 12
months of time in use, at which time the Filter Replacement Indicator will stop flashing
and remain solidly illuminated.
After replacement of your Medi-Filter
®
Cartridge, you must reset the Filter Replacement
Indicator timer. When the timer has been properly reset, the Filter Replacement Indicator
will turn off.
Resetting the Filter Replacement Indicator Timer:
After replacement of your Medi-Filter
®
Cartridge, the Filter Replacement Indicator timer
can be reset by performing the following steps:
1. Plug unit into outlet.
2. Press power On/Off switch to the On (“I”) position.
3. Allow unit to start running at low speed.
4. PRESS and HOLD both the Up and Down Arrow Buttons until the Filter
Replacement Indicator starts to blink.
5. Release both the Up and Down Arrow Buttons.
6. While the Filter Replacement Indicator is still flashing, again PRESS and HOLD
both the Up and Down Arrow Buttons until the Filter Replacement Indicator
turns off.
If the steps above have been performed properly, the Filter Replacement Indicator will
turn off and not flash again for 11 months. If the Filter Replacement Indicator remains on,
repeat the steps again.
Note that in step 6 above, the Filter Replacement Indicator MUST still be flashing
when the buttons are pressed the second time. The Filter Replacement Indicator will
continue to flash for approximately 3 seconds after the buttons are released as required
in step 5 above.
Note: To order replacement filters, call your Authorized FilterQueen
®
Distributor or call
1-440-846-7800.
4
Filter Replacement

Other manuals for FilterQueen Defender