FIMAK SPM-40 - Page 77

FİMAK
DD.009 / Rev. No 00 SPİRAL MİKSER MAKİNASI
Tarih 10.10.2012 Sayfa 77 / 92
4.2 BELT TIGHTENING
In every 15 days, after
loosening the engine
tray fixing screws (A)
the tension is reduced
by the tensioning
screw (B) which is
located at the back of
the machine and then
fixing screws (A) is re-
tightened.
In every 15 days, open the
grill cover and loosen the
tension belt and also check
the tension of engine tray.
In every 15 days, open the
grill cover and tighten the
tension screw, also check the
tension of belts by hand.
Maintenance Instructions
A
B