Finlux FXT8 120T - User Manual

Questions and Answers

A
Austin ThompsonAug 16, 2025
Why does my Finlux FXT8 120T not start?
- J
  Jessica CopelandAug 16, 2025
  If your Finlux Washer doesn't start, there are several possible reasons. First, ensure the machine is properly plugged in and that the fuses are not faulty (replace them if they are). Check that there is mains power supply. Also, make sure you have pressed the Start/Pause button and that the programme dial is not in the ‘stop’ position; turn it to the desired setting. Finally, ensure that the machine door is completely closed.
D
deckerchristopherAug 19, 2025
How to stop my Finlux FXT8 120T from vibrating?
- S
  salassherriAug 19, 2025
  If your Finlux Washer is vibrating, it could be due to several reasons. Ensure the feet of the machine have been properly adjusted. Check that the transit bolts, used for transportation, have been removed. Avoid setting up your washing machine on a hard surface. Also, avoid overloading the drum and ensure that laundry is spread evenly inside.
F
foxbryanAug 22, 2025
What to do if my Finlux Washer does not intake water?
- M
  Megan PhamAug 22, 2025
  If your Finlux Washer isn't intaking water, start by checking if the water tap is turned on. Inspect the water inlet hose to ensure it's not twisted; untwist it if necessary. Also, the water inlet hose or the inlet filters might be clogged, so clean them. Finally, make sure that the machine door is completely closed.
C
Charles BaileyAug 26, 2025
Why is my Finlux Washer not discharging water?
- T
  Tara PhamAug 26, 2025
  If your Finlux Washer isn't discharging water, check the drain hose for clogs or twists; clean or untwist it as needed. Also, the pump filter might be clogged, so clean it. Ensure that your laundry is spread evenly in the machine.
B
Brooke RangelAug 28, 2025
How to reduce excessive foam in my Finlux FXT8 120T Washer detergent drawer?
- C
  Caitlin AndrewsAug 28, 2025
  If you notice excessive foam in the detergent drawer of your Finlux Washer, it might be due to using too much detergent or using the wrong type. To stop the foam, press the Start/Pause button, then dilute one tablespoon of softener into 1/2 litre of water and pour into the detergent drawer. Press the Start/Pause button again after 5-10 minutes. Make sure you only use detergents specifically produced for automatic washing machines. Also, consider whether your washing is too dirty for the programme you selected; refer to the programme tables to choose the most appropriate one. If you haven't used enough detergent, use the amount instructed on the packaging.
P
Patricia BentleyAug 31, 2025
Why does water discharge as soon as my Finlux FXT8 120T Washer is loaded?
- A
  Alice BatesAug 31, 2025
  If your Finlux Washer is loaded with water and water discharges immediately, it could be because the end of the water drain hose is too low. Check that the drain hose is at a suitable height.
J
Jeremy MortonSep 3, 2025
Why am I getting an unsatisfactory washing result from my Finlux Washer?
- A
  Alexander WhitneySep 3, 2025
  If your Finlux Washer isn't providing satisfactory washing results, it could be due to hard water. Try increasing the amount of detergent, following the manufacturer’s instructions. Also, make sure that your laundry is spread out in the drum.
B
Bradley KochSep 6, 2025
How to remove detergent residue from laundry after washing in my Finlux FXT8 120T?
- J
  John HoffmanSep 6, 2025
  If your laundry has detergent residue after washing in your Finlux Washer, non-dissolving particles of some detergents may appear as white spots. Try performing an extra rinse cycle. Alternatively, clean your laundry with a brush after it dries.
J
jensenkaylaSep 9, 2025
Why do grey spots appear on laundry washed in my Finlux Washer?
- A
  Adam ThompsonSep 9, 2025
  If grey spots appear on your laundry after using your Finlux Washer, it may be because there is untreated oil, cream, or ointment on your laundry. Use the amount of detergent as instructed on the packaging in the next wash.
J
Jenny LaneSep 12, 2025
Why is the spin cycle delayed in my Finlux FXT8 120T?
- R
  rlynchSep 12, 2025
  The spin cycle may be delayed or not occur in your Finlux Washer because the Unbalanced load control system has been activated. This system will attempt to spread your laundry. The spinning cycle will begin once your laundry is spread. For the next wash, load the drum evenly.