Finnlo Loxon - 5.4.3 Program Mode; 1) Program Selection

30
1) PROGRAM-Selection
5.4.3 PROGRAM-Mode
check 2) Profile selection
2) Profile selection
P1-P12
3) Setting of values
OFF, 10:00-99:00min
OFF, 120-199bpm
→
→
Starting your exercise, the already set data will start
counting backwards. If the set data reach 0, the
computer will stop and a beep will be heard. If you
didn´t set any values, all data will start counting up.
Starting your exercise, the already set data will start counting
backwards. If the set data reach 0, the computer will stop and
a beep will be heard. If you didn´t set any values, all data will
start counting up.