FIORENTINI I 16 - Squeegee Blades Replacement

INSTRUCTIONS FOR STARTING AND USE
I 16/18 NEW
Rev. 00
22/05/08
Pag. 28/36
4.7.9 SQUEEGEE BLADES REPLACEMENT
The squeegee blades (picture 4.14) have to be replaced as the touching edge is worn; actually the perfection
Of the edge is essential for a perfect drying.
To replace the blades do as it follows:
 Take off the squeegee and put it on a bench.
 Take away the inside and outside bolts (detail 1 picture 4.14), the steel strips (detail 2) and remove
worn blades (detail 3).
 Insert the new ones and the strips fitting the bolts, then the squeegee.
4.7.10 BRUSH PRESSURE REGULATION
When the machine is scrubbing, it is possible to adjust
the brush height from the ground, in order to vary its
pressure on the floor.
Rotating the knob anti-clockwise (particular 1 fig. 4.15)
the pressure increases. Rotating it clockwise the
pressure decreases.
PICTURE N° 4.14
2
3
1
PICTURE N° 4.15
1