FireCam HD DASH CAMERA WI-FI - Fire Cam HD Wifi Dash Camera Overview; LED Status; Initial Set Up

FIRE CAM HD WIFI DASH CAMERA OVERVIEW
LED Status
REMARKS:
When connected to the Power Supply, the RED charging LED is ON in all modes except when the internal
built-in Li-Po battery is fully charged.
Initial Set Up
1. Please ensure the camera is OFF before you insert or take
out the Micro SD card.
2. Open the Micro SD card slot cover.
3. Install a micro SD memory card (max up to 64GB(FAT32))
into the card slot with contacts facing upwards.
4. If no micro SD memory card is inserted,
the Status Indicator LED will flash red and blue and the camera
will shut OFF after 30 seconds.
5. When using a micro SD memory card, there should be no
DATA from other devices on the card. If you are using a
micro SD memory card for the first time,
you should first format (FAT32) the card in your computer.
It is recommended to use Class 6 or above.
An easy way to format on a PC or MAC is to download the FREE SD Formatter at:
https://www.sdcard.org/downloads/formatter_4/!
Status
Table
Lens
Module
LED (Top)
Camera Module
Charging
Indicator
LED (Back)
Camera Module Status
Indicator LED x 2 (Top)
Buzzer
LED
Colour
RED
RED
BLUE
RED
BLUE
BEEP
Power ON
ON
OFF
Flashing
Flashing
OFF
3 Times
Power
OFF
ON
OFF
Flashing
ON
OFF
6 Times
Recording
Video
Flashing
ON
OFF
Slow
Flashing
Wi-Fi
Connected(ON),
Connecting
(Flashing),
Disconnect(OFF)
1 Time
Stop Video
Standby
ON
ON
OFF
ON
OFF
2 Times
Long Beep
Card Slot
Empty
Fast
Flashing
OFF
OFF
Flashing
Flashing
2 Seconds
Micro SD
Card Full
Fast
Flashing
ON
OFF
Fast
Flashing
OFF
4 Times
Battery
Charging
ON
OFF
OFF
OFF
OFF
OFF
Low
Battery
ON
ON
Flashing
ON
OFF
OFF