Installation Steps:
1. Rotate the Rod Sections to fully assemble with all
four sections ③④⑤⑥.
2. Install the Height Adjustable Bracket ⑨ onto the
assembled sections, and install the Top Ceiling Skid
Plate ⑦ to the top of the rod sections.
3. Fix the Adjustable Stable Tripod ② and place it at
the chosen place, buckles on tripod legs can be
unlocked to extend the legs’ length. Note: Buckles
need to be locked for stability.
4. Fix the Tail Rod ① into the tripod slot and tighten
the clamp screw on the top collar.
5. Assemble Tail Rod ① with the Rod Sections
assembled in step 2.
6. Rotate twist-lock telescopic sections and press
the pedal in Tail Rod ① to adjust necessary height.
7. Adjust the bracket position on the pole through
pole lock. Install the laser unit onto platform through
1/4"-20 male thread or 5/8"-11 thread adapter
included.
8. Rotate the fine-tuning knobs on the bracket to
adjust the platform height, and the connector knobs
on the bracket to horizontally rotate the laser level
mounted.
To Next Page
Loading...