7.3 Manual Operation
Control through the main module on the heater:
P0 indicator appears on the screen when the heater is switched on and it is in stand by
mode.
The 1
st
digit on the screen illustrates P symbol while 2
nd
digit illustrates power level mode
from 1 to 3.
The button number 1 on the heater functions as ON / OFF. The heater starts operating at
the power level mode at which it has been switched off.
Press the button number Temi on the heater to adjust power mode.
P0 appears on the screen when pressed ON / OFF button and the power level mode (P1，
P2，P3) can be adjusted through the buttons on the remote control.
Press ON / OFF button on the remote control or the heater itself to switch off the heater.
The heater starts functioning in stand by mode after electricity cut.
LED keeps flashing in case of a program set by remote control.
Buzzer signal is given following each command.
LED
Power level indicator
P
ON/OFF/Power mode button Timer button
To Next Page
Loading...
Need help?
Power
Remote Control
